Tyco Electronics Galaxy SC Controller J85501F-1
Issue 13 February 2001 Operation 6 - 35
To force a login as a super-user or administrator precede the password
with an exclamation mark (!). The current security level is reflected by
the command prompt as follows:
* user security level
** super-user security level
*** administrator security level
To change a password requires the administrator security level. To
change a password login as the administrator and use the PAS
command. See the T1.317 command description section of this manual.
Access Port
Security Hardware/
Software Switch
Management
The state of both the hardware and software security switches can be
viewed from the T1.317 interface. The software security switch can be
set from the T1.317 interface. When viewing security switches from a
T1.317 interface, the reason for limited access will be displayed in
parenthesis as either HW for hardware switch, SW for software switch,
or both. Listed below are the possible responses when viewing the state
of the security switches.
0(HW,SW) access is limited by both hardware
and software switches
0(HW) access is limited by the hardware switch
0(SW) access is limited by the software switch
1 full access is allowed
The examples below illustrate commands that can be used to view
security switch states or to change the software switch state:
STA MP1,WRE view the modem access port security switch
setting
STA LP1,WRE view the local access port security switch setting
STA AU1,WRE view the auxiliary access port security switch
setting
CHA MP1,WRE=0 set modem access port software switch to allow
limited access.
CHA LP1,WRE=1 set local access port software switch to allow full
access.
The stae of the Enhanced Romote Security DIP switch can be viewed
from software.
Call-Back Security
Management
Before using call-back security a phone number and baudrate must be
configured for the location being called and call back security must be
To Next Page
Loading...
Need help?
General
