Tyco Electronics Galaxy SC Controller J85501F-1
Issue 13 February 2001 Operation 6 - 37
change the local port application
to event logging
STA LP1,APP check the status of the application
attribute
STA LP1,STT see if anyone is logged in to the local port
When viewing the application attribute of the local port the application
will be indicated as well as the reason for that application. The table
below defines the possible return values:
TERMINAL(HW,SW) set to terminal in software and hardware
TERMINAL(HW) set to terminal in hardware only
TERMINAL(SW) set to terminal in software only
EVENT LOG set to event log in both hardware
and software
To access the login history log for any of the serial access ports use the
commands listed below. For more information on the login history logs
see the history section of this manual.
HIS LP1,STT report local port login history
HIS AU1,STT report auxiliary port login history
HIS MP1,STT report modem port login history
Upgrading the
Intelligent
Controller
Software
To upgrade the intelligent software from the T1.317 interface, start by
logging in at the administrator security level. Then, enter the
UPGRADE command and press the return key when the Galaxy SC asks
if you are sure you want to upgrade the software. The Galaxy SC will
then enter a special upgrade mode and respond with a press any key
prompt. After a key press, the Galaxy SC will display the following
prompt:
A[bort] R[aw] X[modem]
Pressing A will abort the upgrade process by disconnecting the user.
Pressing R will start an ASCII S-record upgrade session. When
prompted to do so, start your local ASCII text upload session and send
the .abs file from your software upgrade distribution disk. Pressing X at
the prompt will start a binary Xmodem upload session. When prompted
to do so, start your local Xmodem upload session and send the .bin file
from your software upgrade distribution disk.
To Next Page
Loading...
Need help?
General
