Tyco Electronics Galaxy SC Controller J85501F-1
6 - 38 Operation Issue 13 February 2001
After the software upload has completed successfully the Galaxy SC
will begin reprogramming the EEPROM chips. Once reprogramming is
completed the user is disconnected and the Galaxy SC re-boots using the
new software.
Statistics Usage To view basic, trend, busy hour, or battery on discharge statistics, use
the following command:
SUM <attribute name>
where <attribute name> is the name of the statistics set of entries. For
example,
SUM DC1,ADC displays the basic statistics for plant load
SUM TR1 displays user configurable trend channel 1
SUM BH3 displays user configurable busy hour channel 3
SUM DC1,BOD displays the battery on discharge statistics
To clear basic statistics, use the following command:
CLS <attribute name>
To configure the source for the busy hour or trend statistics value (and
clear the previous contents of the statistics channel, use the following
command:
CHA <CHANNEL>,SRC=<SOURCE>
where <CHANNEL> is the name of the busy hour or trend statistics
channel. Valid channel names are: TR1, TR2, TR3, TR4, TR5, TR6,
TR7, TR8, BH1, BH2, BH3, and BH4 and <SOURCE> is the name of
any instantaneous measured value.
To configure the busy hour statistics, in addition to the source, the
following items must also be configured:
Starting date: any valid date in the future
Starting hour: starting hour in the range of 0 to 23
Timer Events
Management
From the T1.317 interface timer events can be viewed and configured.
Timer events are identified by the mnemonics T01 through T32. To use
timer events they must be added and then configured: The following
examples illustrate how this can be done:
To Next Page
Loading...
Need help?
General
