Tyco Electronics Galaxy SC Controller J85501F-1
7 - 59 Feature Descriptions Issue 13 February 2001
PHT1: Processor Halt LSF1: Load Share Fuse
CLC1: Clock Changed MAN1: Manual Off
STF1: Self Test Failed ETS1: External Transfer
Shutdown
PGI1: Program Line Invalid RIC1: Rectifier
Incomplete Config
CCH1: Configuration Changed COF1: Queue Overflow
HCL1: History Cleared COR1: Number Did Not
Respond
MOR1: Measure Out of Range NNC1: Number Not
Configured
MTC1: Module Type Conflict POR1: Number Did Not
Respond
MDF1: Module Failure AAC1: ACO Active
BTJ1: Battery Thermal Major ATA1: Alarm Test Active
BTN1: Battery Thermal Minor ATF1: Alarm Test Failed
AMJ1: Auxiliary Fuse Major ATB1: Alarm Test
Aborted
AMN1: Auxiliary Fuse Minor VLA1: Very Low Voltage
FAJ1: External Fuse Major MFA1: Multiple Rectifier
Fail
FAN1: External Fuse Minor LMR1: Limited Recharge
RBF1: Regulation Battery Fuse ERD1: Excess Rectifier
Drain
BTF1: Battery Thermal Fuse ETO1: Engine Transfer
Timeout
BPF1: Battery Power Fuse RPI1: Rectifier/Plant
Inconsistency
ABS1: Alarm Battery Supply BDA1: Battery On
Discharge
VSF1: Sense/Control Fuse HVA1: High Voltage
LVDA1: Low Voltage Fail HFV1: High Float
Voltage
RTL1: Reserve Time Low
For example: (c301 val > dc1 vdc) & bda1 ast will evaluate to TRUE if
channel 3 of module 01 value is greater than the plant voltage AND
there is BD alarm in the system.
To Next Page
Loading...
