Tyco Electronics Galaxy SC Controller J85501F-1
Appendix C - 2 T1.317 Error Messages Issue 13 February 2001
Security Related -220,SECURITY ERROR
Must be super-user or administrator to execute this command. Login at
a higher security level using the LOGIN command and try again.
-221,EXCESSIVE LOGIN ATTEMPTS
The wrong password was entered too many times when trying to login
or change security levels.
-222,LOGIN LIMITED TO USER
The access port is limited to the user security level only. If this is a
problem, set the WRE attribute of the access port object to 1(enable)
from another access port that has super-user privilege or to RD_WR
from the front panel and flip the access port’s “FULL ACCESS” DIP
switch on SW203 of the intelligent controller to the ‘1’(enable) position.
-223,INVALID PASSWORD
An attempt was made to change the password to an invalid value. See
the section on security for a description of valid passwords.
-224,NEW PASSWORD MISMATCH
The first and second passwords entries did not match when attempting
to change a password.
-225,CALL-BACK FAILED
Could not carry out call-back security. Check that the call-back location
was entered correctly and that a phone number is defined for that
location.
-226,ONE SUPER-USER/ADMINISTRATOR ALLOWED
Could not allow super-user or administrator login because there is
already a super-user or administrator login on one of the other access
ports. Wait for the other super-user or administrator to log off or precede
the password with the ‘!’ character to force a login.
Command
Execution Related
-300,INVALID ALIAS
An attempt was made to define an invalid alias. Check that the alias is
not too long and does not conflict with system defined aliases or
commands.
-301,OUT OF ALIAS SPACE
The limit of 50 user defined aliases has been reached. Set old unused
alias equal to ““ to clear them out and make room for new ones.
-302,INVALID COMMAND LINE
The command line was too long.
To Next Page
Loading...
Need help?
General
