Tyco Electronics Galaxy SC Controller J85501F-1
Issue 13 February 2001 T1.317 Error Messages Appendix C - 3
-303,ALIAS FAILED
The aliases are nested too deeply. Redefine alias so that aliases are not
as dependent on other aliases.
-304,INVALID PARAMETER
An attempt was made to change an attribute to an invalid value. Check
that the value is in the proper range.
-305,TYPE MISMATCH
Attribute and value types don’t match. For example, an attempt was
made to assign text to an attribute value expecting a number.
-306,NOT CONFIGURATION ATTRIBUTE
An attempt was made to use the CHA command to change an attribute
that is either read only or needs to be changed using the OPE command.
-307,BAD DATE
-308,BAD TIME
-309,BAD INPUT
Could not understand the date or time input for an RSDATE command.
-310,OBJECT NOT FOUND
An attempt was made to execute a command referencing objects that
don’t exist.
-311,OUT OF MEMORY
This error indicates that the memory resources defined for a specific
function have been used up. This error will occur if there are no more
objects of a given type or there is no more space for new attributes.
-312,COULD NOT DELETE
An attempt was made to delete a system defined object or linkable
attribute.
-313,OBJECT HAS PARENT
An attempt was made to delete an object with a parent or link an object
to a second parent.
-314,LINK EXISTS
An attempt was made to delete an object with children or delete a
linkable attribute that is linked to an object. Use the UNL command to
unlink children from the linkable attributes before deleting an object or
its attributes. This error may also occur if an attempt was made to link a
second object to a linkable attribute that supports only one link.
To Next Page
Loading...
Need help?
General
