Tyco Galaxy SC Controller - Page 371

Tyco Electronics Galaxy SC Controller J85501F-1
Appendix C - 4 T1.317 Error Messages Issue 13 February 2001
-315,LINK NOT FOUND
An attempt was made to unlink an object from an attribute to which it is
not linked.
-316,COULD NOT UNLINK
An attempt was made to unlink an object from an attribute that was not
linked using the LIN command.
-317,CIRCULAR LINK
The LIN command would have resulted in a circular link. A very simple
example of circular link would be one that linked an object to itself.
-318,TOO MANY ARGUMENTS
There are too many arguments in the command line. This occurs when
too much is being done with one command line. Use two commands for
the same operation if possible.
-319,INVALID ATTRIBUTE
The referenced attribute is not an attribute of the referenced object.
-320,INVALID OBJECT
This error occurs when a bad object identifier is referenced in the
command line.
-321,INVALID OBJECT TYPE
Reference has been made to an invalid object type. This error will occur
if an attempt is made to add objects of types that cannot be added.
-322,PATH TOO LONG
The object path is too long to be resolved. Use a shorter object path in
the command line.
-323,INVALID PATH
Could not resolve the given path or the path is not of a valid form.
-324,ATTRIBUTE EXISTS
An attempt was made to add an attribute to an object with an attribute of
the same name.
-325,OBJECT EXISTS
An attempt was made to add an object that already exists in the system.
-327,OBJECT/TYPE CONFLICT
An attempt was made to add a user-defined object with an identifier that
conflicts with an object type. Pick a different identifier for the object.