Tyco Electronics Galaxy SC Controller J85501F-1
Issue 13 February 2001 Product Description 2 - 13
The value of the menu field is displayed as the combination of hardware
and software switches as shown below:
Hardware SW Software SW Field value
OFF (0) OFF DIS(HW,SW)
OFF (0) ON DIS(HW)
ON (1) OFF DIS(SW)
ON (1) ON ENABLE
Some of the fields act like a pushbutton. The ACO (Alarm Cut Off) and
MODE fields in the MAIN menu are examples. When you select the
ACO field, you can toggle between the On and Off states by pressing the
ENTER key. Similarly, select the MODE field and press ENTER to
switch the plant mode from FLOAT to BOOST (or BTP, if the Battery
Thermal Protection is enabled).
Other menu fields display a system report. For example, the ALARM
field in the MAIN menu displays the system alarm report. These data
screens may hold more than eight lines of information. Use the UP or
DOWN ARROW key to scroll the screen for more data. Press the
ESCAPE key to go back to the parent menu screen. At any data screen,
the system will revert back to the parent menu screen if you do not press
a key within about three minutes. At any menu screen, if you do not
press a key within about two minutes, the system will automatically
revert to the DEFAULT screen.
The controller is factory set for almost all required alarm and control
functions, but these settings and many others can be changed from the
front panel. Refer to Section 4, Configuration, for detailed instructions.
To Next Page
Loading...
Need help?
General
