Tyco Electronics Galaxy SC Controller J85501F-1
Appendix D - 16 TL1 (Transaction Language 1) and X.25 Interface Issue 13 February 2001
For software enable, send the following command through the local
port:
cha au1, wre = 1
Command Format The format of an input command from OS to Galaxy is a command word
followed by a variable number of fields of command-specific
information separated by colons. The command is terminated by a
semicolon. A typical command format is given below:
Command: TID: AID: CTAG: GB: PB;
Command This term designates the command string. Galaxy supports the
following commands.
Activate User
Cancel User
Retrieve Header
Retrieve Alarm
Retrieve Equipment
Report Alarm
Retrieve Alarm Environment
Set Alarm Cutoff
Operate Alarm Cutoff
Report Alarm Environment
Report Removal
Report Restoration
Read Memory
Write Memory
TID (Target
Identification)
This term identifies a particular NE. For Galaxy, the first fifteen
characters of the System Description is used as TID for communicating
with OSs.
AID (Access
Identification)
The access code contains the information needed to access or address
entities within the target NE (Galaxy in this case). For each TL1
channel, this is a configurable parameter. For example, if a particular
TL1 channel is linked to Rectifier 1 in a -48 volt battery plant, the AID,
as recommended by Bellcore’s document TA-NWT-001360, Generic
Requirements For Power Systems Messages At The OS/NE Interface, is
“N48B1RECT1” for that particular TL1 channel.
To Next Page
Loading...
Need help?
General
