Tyco Galaxy SC Controller User Manual

Tyco Electronics Galaxy SC Controller J85501F-1
Issue 13 February 2001 TL1 (Transaction Language 1) and X.25 Interface Appendix D - 21
The Galaxy generates the following error response for requests made for
an AID not present in the system, or for channels with matching AIDs
that are not enabled for TL1 reporting by the user’s configuration:
response header
M^^CTAG^DENY cr lf
^^^IIAC
cr lf;
Retrieve Alarm Environment
Request for environmental alarm information from all AIDs for objects
that are configured as Environment for TL1 reporting
RTRV-ALM-ENV::ALL:CTAG;
Request for environmental alarm information from a specific AID for
channel that is configured as Environment for TL1 reporting
RTRV-ALM-ENV::AID:CTAG;
The Galaxy generates the following responses:
Response with no active alarms
response header
M^^CTAG^COMPLD cr lf;
Response with active alarms
response header
M^^CTAG^COMPLD cr lf
^^^"AID:alarm level, condtype,,,\"conddesc\" " cr lf
...
^^^"AID:alarm level, condtype,,,\"conddesc\" " cr lf;
Set Alarm Cut-Off
The Galaxy sets the alarm cut-off mode if the following command is
issued:
SET-ACO-EQPT::AID:CTAG::ACOMODE;
where ACOMODE represents the mode of ACO operation that is to be
performed by the Galaxy. Valid ACOMODE values are:
MAN : ACO is introduced by Operate Alarm Cut-off command or by
manual operation (front panel) at the Galaxy.
DELD: ACO is introduced automatically at the Galaxy, but is delayed for
approximately 5 seconds to allow a brief audible announcement of
the trouble.

Tyco Galaxy SC Controller Specifications

General

Brand	Tyco
Model	Galaxy SC Controller
Category	Controller
Language	English