Tyco Galaxy SC Controller User Manual

Tyco Electronics Galaxy SC Controller J85501F-1
Appendix D - 22 TL1 (Transaction Language 1) and X.25 Interface Issue 13 February 2001
IMED: <T>ACO is introduced automatically and immediately at the
Galaxy.
AID in the command should be specified as ALL since all alarms having
specified severity in ACO object configuration will be affected. Refer to
Appendix B for attributes of ACO1 object.
The Galaxy generates the following response:
response header
M^^CTAG^COMPLD cr lf;
Operate Alarm Cut-Off
Request for introducing ACO automatically and immediately at the
Galaxy.
OPR-ACO-ALL::AID:CTAG;
AID in the command should be specified as ALL since all alarms having
specified severity in ACO object configuration will be affected.
The Galaxy generates the following response:
response header
M^^CTAG^COMPLD cr lf;
Backup Configuration
This command allows the Alarm Center to store all of Galaxy’s
configuration in an ASCII format. Before using this feature, make sure
that the Alarm Center is prepared to receive data. The TL1 input format
for the backup command is:
RD-MEM-FILE::,AID>:<CTAG>;
If backup and restore are disabled through the auxiliary port, Galaxy
will respond with a privilege error:
M^^ctag^DENY cr lf
^^^PICC cr lf;
In this case, see “Backup or restore” in this Appendix.
If backup is permitted, Galaxy will respond with the following
information:
IP<CTAG><cr><lf><
<configuration data>

Tyco Galaxy SC Controller Specifications

General

Brand	Tyco
Model	Galaxy SC Controller
Category	Controller
Language	English