Tyco Electronics Galaxy SC Controller J85501F-1
Appendix D - 24 TL1 (Transaction Language 1) and X.25 Interface Issue 13 February 2001
Activate User
Before activating user, configure the auxiliary port for TL1 application.
See “Auxiliary Port” on page 1 of this Appendix.
The Galaxy accepts the following command to activate a session (i.e.,
login to the system):
ACT-USER::uid:CTAG::passwd;
Where:
uid user identifier, having the hardcoded value of “user”
passwd password, an ASCII string of up to 10 alphanumeric characters
as specified by the user on screen
The following message is sent in response to a successful login attempt:
response header
M^^CTAG^COMPLD cr lf
Notes:
• When establishing the connection, this command should be
preceded by leading semi-colons to flush the input buffer from
unwanted characters. The command issued will look like:
;;ACT-USER::uid:CTAG::passwd;
• There is no response for unsuccessful login attempts.
• The Galaxy does not transmit any messages until a user
successfully logs into the system.
Cancel User
The Galaxy accepts the following command to terminate a user session
on the system (i.e., logout):
CANC-USER::uid:CTAG;
Where:
uid user identifier, having the hardcodeed value of “user”
The Galaxy generates the following response upon receipt of a valid
cancel user command:
To Next Page
Loading...
Need help?
General
