Tyco Galaxy SC Controller User Manual

Tyco Electronics Galaxy SC Controller J85501F-1
4 - 6 Configuration Issue 13 February 2001
Methods of
Configuring
Galaxy
This chapter covers three methods of configuring the Galaxy SC: front
panel, remote terminal using T1.137 command language, and by using
EasyView software installed on a personal computer.
Refer to Appendix D, TL1 (Transaction Language 1) and X.25
Interface, for installation and configuration of this command interface.
Front Panel Changes in plant and rectifier configuration may be made directly from
Galaxy SC’s front panel. In a Basic Controller (no Intelligent features),
only front panel interface is available. BJB (Basic Controller) SW202-8
must be closed (1) to enable configuration via the front panel. These
methods are described in the following sections: “Basic Controller Front
Panel Configuration” and “Intelligent Controller Front Panel
Configuration,” respectively.
EasyView Software With Intelligent features installed, EasyView software may be used to
make changes in plant and rectifier configuration. Refer to “EasyView
Software Communication Mode.”
Remote Terminal All of the communication between the user and Galaxy SC over a
remote terminal may also be completed without EasyView by directly
accessing one of Galaxy SC’s available ports and utilizing the T1.317
command Language. Refer to Appendices A and B for a complete
review of T1.317 and this access mode and the last portion of Section 6
ETS External Transfer
Shutdown
Minor RECT None
HPA Half Power Minor RECT None
LCA Low Current Alarm Minor RECT None
LSF Load Share Fuse Minor RECT None
MAN Manual Off Minor RECT None
PHA Phase Or Low
Output
Minor AC None
RFA Rectifier Fail Minor RECT RFA
Table 4-C: Rectifier Alarm Defaults
Symbol Default Designation
Default
Severity
Default LED Default Relay

Tyco Galaxy SC Controller Specifications

General

Brand	Tyco
Model	Galaxy SC Controller
Category	Controller
Language	English