TYM T303HST - Page 40

8) Disconnect the rubber hose from the suction
pipe.
(2) Engine separation from the chassis.
When separating the engine from the
chassis, the following steps are required
as well as the ones mentioned above.
1) Lift the engine with the hoist and hold
FIG.2-20 suction pipe.
2-10
1) Lift the engine with the hoist and hold
the front axle bracket with a stands or the
like.
2) Disconnect the upper, Lower ,and drain
hoses from the radiator.
3) Disconnect the two power steering
system hoses.
FIG.2-21 Line up
4) Remove the fuel hose.
5) Disconnect the the inlet pipe.
6) Loosen the right hand pivot metal
tightening bolts beforehand.
7) Separate the engine from the front axle
bracket.