typical GT1790A - Re-sewing Procedure

-
29
-
7. Performing re-sewing
When stop switch A is pressed during sewing
operation, the sewing machine will stop. At this
moment, error display screen B is displayed to
inform that the stop switch is pressed.
To continue performing sewing from some point in
sewing
Sewing motion stop status
Error display screen B is displayed
1) Release the error
Press Reset key
❸
| to release the
error. Then the step motion screen C is
displayed.
2) Return the presser
Press Backward key ❼-1 and the
presser returns stitch by stitch. Press Forward
key❼-2 and the presser advances
stitch by stitch. Return the presser to the
re-sewing position.
3) Restart the sewing
Depress the right pedal to restart the sewing.
Perform again the sewing work from the start.
Sewing motion stop status
Error display screen B is displayed
1) Release the error
※Existing number of stitches/total number of stitches are
displayed in section D.
※Existing sewing command is displayed in section E.
Sewing command
Jump feed command
Thread trimming
command
Knife command
Error No.
Error icon