-
49
-
17. Performing continuous sewing
The sewing machine can achieve continuous sewing of plural pattern without raising presser.
The sewing machine can sew the maximum of six types of shapes automatically in one cycle.
Moreover, it can register the maximum of 20 data.
Please copy it before use if required. Refer to “V-14. Copying sewing pattern” P.39.
*It is necessary to change the parts from the state at the time of your purchase according to the setting conditions.
(1) Selection of continuous sewing data
1) Set the mode to the input mode
Under the input mode where Set Ready LED
goes out, the continuous-sewing data selection
is enabled. In sewing mode, press Ready key❷
to change over the mode to input
mode.
The continuous sewing data can be selected only
in input mode.
2) Call the pattern selection screen
Press Item Selection key ❻ , to select
continuous sewing screen A.
3) Selecting continuous sewing data
Press Data Change key ❼ , to select the
intended continuous sewing data No. B.
When the continuous sewing data is selected,
press the Ready key ❷ , then the Set
Ready LED will light up, indicating that the
sewing is enabled.
Continuous stitching data No. 1 only has been
registered at the time of your purchase. Sewing
status cannot be obtained since the sewing pattern
has not been input. Therefore, please refer to (2)
Editing method of continuous sewing data next
page for input.
To Next Page
Loading...
