-
70
-
(1) Thread take-up spring ((purl stitch)
1) The thread take-up amount of thread take-up
spring① is 8 to 10mm, and the appropriate
pressure at the start is approximately 0.06 to
0.1N.
2) To change the stroke of the thread take-up spring,
loosen screw②, insert a thin screwdriver into the
slot of thread tension post③, and turn it.
3) To change the pressure of the thread take-up
spring, insert a thin screwdriver into the slot of
thread tension post③ while screw② is tightened,
and turn it. Turning it clockwise will increase the
pressure of the thread take-up spring. Turning it
counterclockwise will decrease the pressure.
(2) Adjusting the thread take-up amount of the thread
take-up lever
The thread take-up amount of the thread take-up lever
should be adjusted in accordance with the thickness of
the sewing products.
a. For heavy-weight materials, loosen setscrew② in
thread guide①, and move the thread guide to the
left.
b. For light-weight materials, move thread guide①
to the right. The thread take-up amount of the
thread take-up lever will be reduced.
To Next Page
Loading...
