-
57
-
21. Changing method of memory switch data
1) Set the mode to the input mode
Under the input mode where Set Ready LED goes
out, changing of memory switch is enabled. In sewing
mode, press Ready key❷ to change over the
mode to input mode.
2) Call memory switch data editing screen
Press Mode key❹ to display the mode screen
(operator level).
You can choose memory switch data in this screen
(level 1).
Press Mode key❹ for 3 seconds and then mode
screen (maintenance personnel level) will be displayed.
You can choose memory switch data in this screen
(level 2).
3) Select memory switch data to be changed
Press Item Selection key❻ , and select the data item
to be changed.
For the memory switch data, there are data item that
changes numerical value and data item that selects the
icon.
No. such as is attached to the data item which
changes numerical value. Increase or decrease the set
value with Data Change key❼ to change the
value.
No. such as is attached to the data item which
selects icon. Icons can be selected with Data Change
key❼ .
Refer to “V-22. List of memory switch data” p.52 for
details of memory switch data.
To Next Page
Loading...
