typical GT1790A - Sewing Data Copying Procedure

-
45
-
14. Copying sewing data
Data of pattern No. which has been already registered can be copied to pattern No. which has not been used.
Overwriting copy of the pattern is prohibited. When you desire to overwrite, perform it after erasing the
pattern once.
1) Set the mode to the input mode
Under the input mode where Set Ready LED
goes out, copying is enabled. In sewing mode,
press Ready key ❷ to change over the
mode to input mode.
2) Select pattern No. of copy source
Press Item Selection key ❻ , and select the
source pattern No.
Refer to “V-5. Selecting pattern” P.24.
When creating new pattern data, it is convenient to
copy the initial value pattern.
 Refer to “V-10. Using the initial value pattern”
P.30.
3) Call copy screen
Press Copy key , and copy screen A will
be displayed.
4) Select pattern No. of copy destination.
Pattern No. B which is not used is displayed. Press
Data Change key ❼ to select a No. to be
used for copying.
If you want to erase the pattern, select the garbage
can .
5) Start Copying
Press Ready key ❷ to start copying. The
pattern No. which is created by copying returns to
the input screen in the state of being selected.
Press Reset key ❾ , and the screen returns
to previous one without copying.
※ Cycle data and continuous stitching data
can be copied by the same method.