typical GT1790A - Page 43

-
40
-
No.
Item
Setting range
Edit unit
Remarks
S010
Correction of right bar-tacking width
This item adjusts right-side outer shape of bar-tacking
section and the overedging section.
Both 1
st
and 2
nd
bar-tacking sections are corrected.
-1.00 ~ 1.00
0.05 mm
-
S011
Correction of left bar-tacking width
This item adjusts left-side outer shape of bar-tacking section
and the overedging section.
-1.00 ~ 1.00
0.05mm
-
S012
Taper bar-tacking offset, left
This item sets length of bar-tacking section which forms the
taper bar-tacking shape.
0.00 ~ 3.00
0.05mm
*1
S013
Taper bar-tacking offset, right
This item sets length of bar-tacking section which forms the
taper bar-tacking shape.
0.00 ~ 3.00
0.05mm
*1
S014
Eyelet shape length
This item sets the upper side length from the center of eyelet
of eyelet shape.
1.0 ~ 10.0
0.1mm
*1
S015
Number of stitches of eyelet shape
This item sets number of stitches in the upper 90˚ of eyelet
shape.
1 ~ 8
1
*1
S016
Eyelet width
This item sets crosswise size of the inside of eyelet shape.
Actual needle entry point is the dimension to which S04
Knife groove left width is added.
1.0 ~10.0
0.1mm
*1
S017
Eyelet length
This item sets lengthwise size of the inside of eyelet shape.
1.0 ~ 10.0
0.1mm
*1
S018
Round-type shape length
This item sets upper length from the center of round type
shape.
1.0 ~ 5.0
0.1mm
*1
S019
Number of stitches of radial shape
This item sets number of stitches in the upper 90˚ of radial
shape.
1 ~ 8
1
*1
S020
Reinforcement of radial shape
This item sets whether to conduct reinforcement stitching of
radial shape.
-
-
*1, *2
*1: Displayed according to the shape.
*2: Displayed when it is set to with edit. Refer to “V-12. Method of setting sewing data with/without edit” p.32.
*3: Displayed when the function is selected.
Top of
square type
Bottom of
square
type
Bottom of straight
bar-tacking
Top of
square type
Bottom of
square
type
Bottom of straight
bar-tacking
Top of round
type
Top of radial
type
Top of semilunar
type
Bottom of
round type
Bottom of radial
type
Bottom of semilunar
type
Yes
No