typical GT1790A - List of Memory Switch Data (Level 2)

-
59
-
No.
Item
Setting range
Edit unit
Initial value
U018
Cloth cutting knife size
Input knife size used.
3.0 ~ 32.0
0.1mm
32.0mm
U019
Plural motions of cloth cutting knife disabled/enabled
Disabled Enabled
-
-
Disabled
U020
Thread trimming detection function disabled/enabled
Disabled Enabled
-
-
Enabled
U021
Selection of presser position when Ready key is on (up/down)
Set presser position when Ready key is pressed.
Presser up
Presser down
-
-
Presser up
U022
Selection of presser position at the end of cycle sewing (up/down)
This item sets the position of presser at the end of one cycle sewing.
(Enabled only for 1-pedal setting)
Presser up
Presser down
-
-
Presser up
U023
Needle thread trimming motion start distance
Distance from the start of sewing to the start of needle
thread trimmer release motion is input.
0 ~ 15.0
0.1mm
1.0mm
U024
Bobbin thread trimming motion start distance
Distance from the start of sewing to the start of bobbin
thread trimmer release motion is input.
0 ~ 15.0
0.1mm
1.5mm
U025
Counter updating unit
Set the unit for updating sewing counting
1 ~ 30
1
1
U026
Total number of stitches not displayed/displayed
Not displayed
Displayed
-
-
Not
displayed
U027
LED light luminance setting
0 ~ 5
1
5
U500
Language selection
The language to be used for the display on the sewing panel is selected.
※
The number of selectable languages differs depending on the
specifications of the sewing machine at the time of shipment.
-
-
Not selected