Version 1
11
Standard Accessories
Headset
This heavy-duty headset is designed for use with or without a hardhat and can block out intense sounds
often found in industrial environments so that the user may easily hear the sounds received by the UL-
TRAPROBE. In fact, these headphones provide over 23dB of noise attenuation.
WTG-1 Warble tone generator
The WTG-1 Tone Generator is an ultrasonic transmitter designed to flood an area with ultrasound. It is
used for a special type of leak test. ‚When placed inside an empty container or on one side of a test item,
it will flood that area with an intense ultrasound that will not penetrate any solid but will flow through any
existing fault or void. By scanning with the Trisonic Scanning Module, empty containers such as pipes,
tanks, windows, doors, bulkheads or hatches can be instantly checked for leakage. This Tone Generator
is a WARBLE TONE GENERATOR. This internationally patented transmitter sweeps through a number
of ultrasonic frequencies in a fraction of a second to produce a strong, recognizable „Warble“ signal. The
warble tone prevents a standing wave condition which can produce false readings and provides for a
consistency of testing in practically any material.
Rubber focusing probe
The Rubber Focusing Probe is a cone-shaped rubber shield. It is used to block out stray ultrasound and
to assist in narrowing the field of reception of the “Trisonic“ Scanning Module.
Stethoscope Extension kit
This consists of three metal rods that will enable a user to reach up to 78 cm (31 additional inches) with
the Stethoscope Probe.
BCH-10L Battery charger
This is the standard battery charger for the UP10000 with a line input of 120VAC @ 60Hz. The charging
time is about 4 hours. (For countries with 220 V/ 50 Hz, adaptors are available for the BCH 10L.)
LRM-/10
A cone shaped scanning module that increases the detection distance above standard scanning mod-
ules. The LRM-9 is ideal for high voltage inspection and for locating leaks at great distances.
RAS/RAM Remote magnetic transducer
The RMT is used as a contact (stethoscope) and is mounted on magnetic metal housings. It is used
when probe placement is necessary for consistent trend monitoring or when access is difficult
To Next Page
Loading...
Need help?
General
