UE Systems ULTRAPROBE 10000 User Manual

Version 1
32
5. Click to set
6. Press the Yellow ENTER button to exit
Menu 20: Display Response
You can control the speed at which the bar graph moves and the meter responds to reflect a dB level.
There are three choices: Slow, Medium, Fast. The instrument defaults to Slow. To select a response
speed:
1. Follow the steps to Enter the Setup Mode as de-scribed earlier
2. Spin to Menu 20: Display Response
3. Click to Enter
4. Spin to select Slow, Medium or Fast
5. Click to set
6. Press the Yellow ENTER button to exit.
Menu 20
Select
Display Response
Display Response
Response = (SLOW)
Press ENTER to Exit
Menu 21: Comm Flow Control Off On
Note: If you’re not using hardware handshaking flow control, keep this option OFF.
1. Follow the steps to Enter the Setup Mode as described earlier
2. Spin to Menu 21: Comm Flow Control
3. Click to Enter
4. Spin to ON or OFF
5. Click to set
6. Press the Yellow ENTER button to exit
Comm Flow Control
Comm Flow Control
OFF
ON
CTS is 1
CTS is 1
DTR is 1
DTR is 1
Menu 22: Line Input
With line input you can enter data such as Temperature from an external source. The source must have
a DC milivolt output. To input the data:
1. Connect the cable from the Thermometer to the Ultraprobe Line Input jack
2. Enter Setup Mode
3. Spin to Menu 22: “Line Input”
4. Click the Sensitivity dial in to enter
5. Disabled will blink, Spin to Temp Probe
6. Click to set
Menu 22
Line Input Select
Select
Line In = Temp Probe
Comm Flow Control

UE Systems ULTRAPROBE 10000 Specifications

General

Brand	UE Systems
Model	ULTRAPROBE 10000
Category	Measuring Instruments
Language	English