Filling the boilers
As soon as the power is switched on the boilers fill automatically.
Remember to turn on the water stop valve.
Steam boiler
A safety function is provided in case the boiler is not filled in within 3 minutes: the filling solenoid valve and
the pump switch off.
In all cases:
Check the water supply to the machine
Switch the machine off and on again: switch the main isolation switch to 0 and then back to 1
Filling starts again
Group boilers
A small amount of water should flow out of each group.
If not, the light bar above the faulty group flashes:
Check the water supply to the machine
Switch the machine off and on again: switch the main isolation switch to 0 and then back to 1
Filling starts again
Switching on the heating
All the elements start heating automatically if filling is correct. When the machine reaches its operating
temperature it is ready to work.
The steam pressure and the group temperatures are displayed on the screen.
We recommend leaving the machine with the heating switched on all the time, and leaving the filter holders
in position on the machine when they are not in use.
When the machine is warmed up
It is not possible to access the menu until the machine is warmed up. Once the machine is at its working
temperature simply press the screen to obtain the menu.
To Next Page
Loading...
Need help?
General
