Unic Stella di Caffe - BTA;BGX;BST Control Box Replacement

61
Tools required:
- Flat screwdriver
- Philips screwdriver, PZ1
 BTA/BGX/BST control box replacement
- Switch the machine off
- Loosen the two screws (A) under the side grilles of the cup warmer, by approximately 1 cm, and
free the front panel from the hooks by pushing the screws towards the back
- Tilt the front panel forward to gain access to the wiring
- Disconnect the connectors connecting the front panel to the machine to remove it.
- Place the front panel flat on a protected surface to avoid scratching it and to have access to the
screws on the back
B
A