1. SAFETY INSTRUCTIONS
- This machine is not intended to be used by persons (including children) with diminished physical, mental
or sensorial capacities, or lacking in experience and savoir faire, unless they are supervised or have
received training in the use of the machine from a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the machine.
- This machine must only be used for its specific intended use.
- The manufacturer accepts no responsibility for damage caused by abnormal or incorrect use.
- Access to the service area is limited to persons having the necessary health and safety expertise and
practical experience of the machine.
- Before connecting or disconnecting the supply cable set the main switch to the 0 position.
- If the supply cable is damaged it should be replaced by the manufacturer, his repairer or a similar qualified
person to avoid danger.
- For electrical safety make sure that the machine is properly earthed.
- The manufacturer accepts no responsibility for damage caused by faulty grounding connections.
- Only qualified technicians are authorised to access the internal parts of the machine for maintenance or
repair.
- Use caution around hot surfaces such as the cup warmer, the group heads and the hot water and steam
outlets.
- Keep well clear of hot water or steam jets.
2. IMPORTANT INFORMATION
This machine must be:
- Placed on a stable horizontal surface
- Used at an ambient temperature between 5°C and 35°C (41°F – 95°F).
- Installed in compliance with any applicable local and national regulations.
- Connected to a water supply at a pressure between 1 and 8 bars
(0.1 to 0.8 Mega Pascal)
Before connecting the electricity supply, check that the mains supply complies with the specifications on the
manufacturer's plate on the machine.
For more details on the installation, adjustment or connections refer to the installation instructions or the
technical manual.
This machine should not be exposed to water jets or splashes.
Take care not to obstruct the machine air inlets with cloths or other objects.
If the machine is stored at an ambient temperature below 5°C (41°F) the hydraulic circuit (boiler and
pipework) must be drained.
To Next Page
Loading...
Need help?
General
