Update procedures
During an update you should:
- If possible save the machine settings on the machine USB dongle (Maintenance data transfer
settings export
- Perform an update of the CPU with a USB+ dongle
- Import the CIM configuration from the machine USB dongle (Maintenance data transfer CIM
import ) or reconfigure the machine using CIM creator
- Import the machine configuration (Maintenance data transfer settings import)
BTA update
- Start the machine and wait for the end of the BTA starting cycle
- At the end of the starting cycle insert the USB + dongle
- The hourglass pointer appears, followed by the update screen
- Uncheck "Calib" to stop the countdown and then check "BTA" and press "upgrade"
If you do not uncheck "Calib", the calibration procedure starts at the end of the countdown.
See BTA calibration procedure
- Confirm "upgrade"
- The control box will restart automatically. The progress of the update is not visible.
- Note: During an update the restarting of the control box takes longer, DON'T SWITCH THE
MACHINE OFF
- Wait for the end of the starting cycle
- When the screen background reappears, the BTA is updated with the time and date.
CPU update
If you have not exported the CIM and the settings, they will be lost and will need to be
reconfigured.
- Proceed in the same way as for the BTA
- check "CPU" and press “upgrade"
To Next Page
Loading...
Need help?
General
