20
SAFETY RULES AND PRACTICES
SURFACE & CAPACITY
WARNING
!
!
• The 1H2 models must be used on only smooth, solid oor
conditions. The following conditions should be avoided at all
times.
-Sand -Gravel
-Oil -Ice
-Mud -Unstable surfaces
• Operating the truck on these surfaces may cause dangerous
conditions for the operator, other personnel and equipment.
DOCKBOARDS (BRIDGE PLATES), TRUCKS AND
RAILROAD CARS (cont’d)
WARNING
!
!
• All types of dockboards shall have a high friction surface
designed to reduce the possibility of employees or trucks
slipping and shall be designed and maintained so that one
end will have a substantial contact with the dock (or loading
platform) and the other end with the transport vehicle to
prevent the dockboard from rocking or sliding.
• When powered industrial trucks are driven on and off
highway trucks or trailers, the brakes on the highway
trucks or trailers shall be applied, and wheel chocks or
other positive mechanical means shall be used to prevent
unintentional movement of highway trucks and trailers.
• Provision shall be made to prevent railroad cars from being
moved during loading and unloading. Wheel stops, hand
brakes, or other recognized positive means shall be used to
prevent movement during loading and unloading.
• Whenever powered industrial trucks are driven on and
off semitrailers not coupled to a tractor, supports may be
needed to prevent upending or corner dipping.
• Maintain a safe distance from the edge of ramps, platforms,
or other similar working surfaces.
• Do not move railroad cars or trailers with a powered
industrial truck unless the truck is properly designed and
equipped for that operation.
To Next Page
Loading...
