70
BATTERY REPLACEMENT
Battery Selection
A battery also serves as a counterweight,
and the lifting capacity will vary according to
the weight of the battery which is mounted
on the forklift.
Accordingly, it is necessary to choose a
battery which is within the battery weight
range specied on the data plate attached to
each forklift.
When using any battery which is not within
the battery weight range specied on the
data plate attached to the forklift, be sure
to contact your Local Authorized Dealer,
and ask them to change the lifting capacity and battery weight range
stamping on the data plate attached to this forklift.
Battery removal and installation
To remove the battery proceed as follows:
1. Align the battery table and the forklift
truck in the proper angle & height.
2. Turn the key switch to the OFF position
3. Disconnect the battery plug.
4. Remove the battery retainer (cover
on “EE”).
5. Slowly pull the battery out of the
truck.
To install, proceed in reverse order.
6. If battery must be lifted to be
changed, apply proper battery lifting
attachments to the battery box, and
then hang the battery by the hoist to
replace the battery.
CAUTION
!
• Be careful not to damage the truck or the equipment when
lifting up the battery.
7. Place a freshly charged battery on the battery table, and then
slowly install it to the forklift truck.
GENERAL CARE AND MAINTENANCE
Battery plug
Battery cover
Battery table (sample)
To Next Page
Loading...
