21
IN CASE OF TIP-OVER
NOTE: These instructions apply to stand-up rider type trucks with a
large rear opening in the drivers compartment.
If the electric stand-up lift truck starts to tip over or fall in any direction,
step off the rear and away from the truck.
WARNING
!
!
• In an electric stand-up lift truck tips or falls off a ramp or
dock, you could be seriously injured, or killed no matter what
you do! The best chance of surviving is to get away from the
truck and load.
• You must step out and away from the driver's compartment.
SAFETY RULES AND PRACTICES
INSTALLATION OF ATTACHMENTS
WARNING
!
!
• The 1H2 series forklifts have been designed for side shift
attachments (refer to "Truck Modications" on page 4).
ANSI/ITSDF STANDARDS FOR FORKLIFT CLAMP
ATTACHMENTS
WARNING
!
!
• The ANSI/ITSDF Standards regarding forklift mounted clamp
attachments took effect for trucks shipped on or after
October 7, 2010. This current standard affects lift trucks
equipped with a load bearing clamp (paper roll clamp, carton
clamp, etc.) and requires the operator to perform two distinct
motions before opening (releasing) the clamp. For example,
the operator must press a button and then move a lever to
release the load.
ANSI B56.1 Section 7.25 “Load-Handling Controls” can be reviewed by
visiting the ITSDF website at www.itsdf.org
To Next Page
Loading...
