56
OPERATING THE TRUCK
OPERATIONAL PROCEDURES (cont’d)
STARTING AND OPERATING
1. Make sure that the ignition switch is in the OFF position, and then
connect the battery plugs correctly. If plugs are not fully connected,
the forklift could overheat and damage the plugs.
2. Ensure the Multifunction handle is in the neutral position.
3. Step into operator compartment. Ensure that one foot is on
operator’s presence foot pedal and the other is on the brake pedal
to release the brake.
4. Make sure that the emergency switch is released.
5. Turn ignition switch on. Make sure that the LCD is ON and make
sure that the LCD is not showing a malfunction indication mark.
The meter panel will indicate to cycle the brake pedal to ensure
proper operation.
WARNING
!
!
• Do not turn the ignition switch ON unless the Multifunctional
Handle is in Neutral.
To Next Page
Loading...
