35
OPERATING CONTROLS AND FUNCTIONS
METERS, INDICATORS AND LAMPS (cont’d)
bATTERY CAPACITY INDICATOR
During forklift operation, periodically check the battery capacity. Make
every effort to recharge the battery before the battery low message
appears.
The controller and the sensors act together to regulate the forklift’s
electrical system. Whenever one of the malfunctions listed below
occurs, the LCD meter panel will show an indication explaining the
details of the malfunction.
WHEEL INDICATOR
Wheel position indicator
This indicator shows the current direction of the driving/steer wheel.
When the steering wheel is turned, the wheel position indicator will
move in accordance with the change of the driving/steer wheel
direction. (Both of the forward and reverse directions of the wheel are
simultaneously indicated.
F
E
Full charge
F
E
Discharge rate
40%
F
E
Discharge rate
80%
F
E
Discharge rate
90%
F
E
Discharge rate
100%
Four green and two
red indicators will
illuminate.
Two red indicators
will illuminate.
Only the frame will
flash.
All indicators
will illuminate.
One red indicator
and the frame will flash.
Recharge the battery.
CAUTION
!
• Turning the steering wheel frequently while the forklift truck
is stopped may cause uneven wear of the tire on the driving
wheel or overload to the EPS motor (steering motor).
WARNING
!
!
• Do not turn the steering wheel quickly while traveling at high
speed to reduce the possibility overturning the forklift truck
or the possibility of the load shifting and falling off the forks.
STATUS DISPLAY
Parking brake indicator
When this indicator is shown, the parking brake is applied. When the
brake pedal is depressed, the parking brake is released and then the
parking brake indicator is replaced with the speedometer. If there is no
travel command given, the brake will reapply. Brake will release when
the next travel direction is selected.
F
E
AM 10:00
F
E
AM 10:00
F
E
AM 10:00
F
E
AM 10:00
0 MPH
Brake ON
Brake OFF
To Next Page
Loading...
