UniCarriers SRX Series - Battery Gate Decal; Pinch Point Decal; EE Decal

28
SAFETY RULES AND PRACTICES
DATA & CAPACITY PLATES AND DECALS (cont’d)
bATTERY GATE DECAL
WARNING
!
!
• Battery gates must be installed before operating the truck.
PINCH POINT DECAL
WARNING
!
!
• This decal instructs the operator to keep ngers away. Do
not reach into the mast area. Personal injury may occur if any
part of your body is between the moving and xed sections
of the mast.
EE DECAL
WARNING
!
!
• "EE" labeled and classied forklifts require special
equipment and enclosures.
• These include but are not limited to; static strap, enclosed
fuse(s), contactors, motors and switches. The battery
compartment is reinforced with battery covers that can be
locked.
• Refer to NFPA 505 for specic location classications and
application guidelines.
• To maintain this classication of electrical protection, all
guards, covers and enclosures must be in good working
order and in place whenever the forklift is in operation. Lock
battery covers should only be removed when servicing or in
approved battery charging areas.
• If damaged in any way, the unit must be taken out of service
until repaired or replaced.