46
Placing a Load onto Rack:
When selecting the loaded PB the automatic fork stop will raise the
forks 100 mm (4 inches) higher than the no load PB so a pallet can be
placed on the rack (100 mm (4 inches) dimension can be changed by a
trained and authorized technician).
• Square truck with rack where load is to be placed.
• Press preset PB programmed for rack level
where load is locat ed.
• At bottom of key pad no load and loaded
pushbutton LED's will turn on.
• Press the loaded PB and the no load LED will
turn off.
• Check that area above load to the selected
rack level is clear.
• Use the multifunction handle to lift the load. Forks will
automatically stop at the preset rack height.
CAUTION
!
• Make sure forks have stopped at correct height before
attempting to load on rack.
WARNING
!
!
• When using the loaded automatic fork stop feature, make
sure there is adequate clearance between the load and the
rack immediately above where the load is being placed.
Continue to pick load from the rack manually.
OPERATING CONTROLS AND FUNCTIONS
METERS, INDICATORS AND LAMPS (cont’d)
USING AFHS FEATURE
Picking Load from Rack
When selecting the no load PB the automatic fork stop will stop the
forks at the proper height to enter a pallet.
• Square truck with load
• Press preset PB programmed for rack level
where load is located.
• At bottom of key pad no load and loaded
push button LED's will turn on.
• Press the no load PB and the loaded LED will
turn off.
• Check that area above forks to load is clear.
• Use the multifunction handle to lift the forks. Forks will
automatically stop at the preset rack height.
CAUTION
!
• Make sure forks have stopped at correct height before
attempting to pick up load.
Continue to pick load from the rack manually.
To Next Page
Loading...
