Unicum NERO TOUCH - Commissioning

User manual for NERO TOUCH, NERO TOUCH INSTANT
page 15
Version 1.1 / December 2017
ТМ
Installation conditions: Mains voltage
• Admissible mains voltage: ~220 V ± 10% 50 Hz
Fig.4.1
Vending machine unpacking
Get the vending machine from the package, and remove all pack-
aging. Because the vending machine should be transported only in the
original package, it’s recommended to save the packaging. The packag-
ing should be recycled in accordance with current environmental legisla-
tion.
Fig.4.2
4.3 Commissioning
Note:
Only skilled technicians can install and put the vending machine in service. Before installing and putting
the vending machine in service read and understand the instructions given in this manual.
After removing the vending machine from the packaging:
1. open the vending machine door by using the key (the key is secured by a tie to the cup shelf or the
cuparrester,seeg.5.1).
2. remove the vending machine components, included in the scope of supply, from the waste contain-
ers,locatedinthelowerpartofthevendingmachine,(seeg.4.2).
1
2
3
4
5
6
7
8
1-Bafeplate(not-INSTANT);
2-Powercable;
3-Passportvendingmachine;
4-Coffeebeancontainer(not-NSTANT);
5-Siliconetubewithterminal(nozzle);
6-Servicekey;
7-Setofextra(spare)fuses;
8 - Hoffmann clamp (option FRESH MILK).