Unicum NERO TOUCH - Waste Container; Autonomous Operations Kit

User manual for NERO TOUCH, NERO TOUCH INSTANT
page 32
Version 1.1 / December 2017
ТМ
Filling milk into the container (for vending machines with FRESH MILK option)
• Install the cooling module next to the vending machine at the left side. Insert the milk supply tube into
the cooling module side port.
• Openthedoorofthecoolingmodule.Removethemilkcontainerandllitwithfreshmilk.
• Placethelledmilkcontainerbackintothecoolingmodule.
• Lower the milk supply tube down to the bottom of the container.
• Close the door of the cooling module.
Note:
The milk should be stored at the temperature from 3.5 to 7
0
С.
Use only cooled fresh long-storage milk (pasteurized or UHT) with 2.5 to 3.6% fat
Fill the container with milk, taking into consideration the maximum capacity of the container.
To avoid problems associated with milk dispensing locate the milk container level with the vending ma-
chine and make sure that the milk supply tube lies on the bottom of the container and has no kinks.
For milk storage, the manufacturer recommends using the special milk cooling module (cooler) that was
compatibilitytestedwiththestandardsofthecountries,wheretheNEROvendingmachineoritsmodica-
tions are going to be used.
The manufacturer can supply the recommended cooling module complete with the vending machine on
demand.
The correspondence of the recommended special cooling module with the standards should be con-
rmedbythemodulemanufacturer.
5.6 Waste container
 Theliquidwastecontainerissituatedinthelowerleftpartofthemachine.Youmustdroptheoatinto
thiscontainer.Thegivenoatactsasthesensorindicatingthecontainer’sleveloflling.
Except for the liquid waste, which is produced during the preparation of drinks, the process of making
coffee from coffee beans, we also have hard waste in the shape of pressed ground coffee, which the es-
presso group throws out into the waste container, situated in the lower left side of the machine. The quan-
tity of waste is monitored programmatically.
When the software counter reaches the maximum number of drinks (set in the technician menu (equip-
ment) - Errors section - Coffee waste number setting), made using the coffee beans, such drinks become
inaccessible.
To set the counter to zero:
• Openthevendingmachinedoor;
• Inserttheservicekeyintothedoortrip(seesection2.2);
• Turnonthevendingmachine(ifit’sturnedoff);
• Removethecoffeewastecontainer(forsolidwastes)andremovethewastes;
• 10secondsafterinsertingthecontainerbackintothevendingmachine;
• Remove the service key and close the door.
5.7 Autonomous operations kit
 Initsstandardcongurationthevendingmachineisconguredtousewaterfromthecanister/bottle,
which is installed near the machine.
 Forwatersupplyconnectionwehaveasiliconewaterpipe,whichcomeswiththepackage(seeg.4.2
pos.5),whichfromoneendisconnectedtowaterinlet(seeg.5.4pos.3)andfromtheotherendofthe
tube is immersed into the source of water (canister/bottle).