UniPOS IFS7002 User Manual

UniPOS IFS7002 two signal loops
Instruction Manual Page 61
Revision 11/01.17 Of 145
The displayed screens have a tree structure of subordinate menus (Appendix 2b). Transition to a
lower hierarchy menu is performed via button (Enter); to revert to a previous/ upper hierarchy
menu use button (Cancel). To move between elements of a single menu use buttons
(Up) and (Down) – when the menu appears as ascending window from the left bottom corner
of the screen, or buttons (Move Up) and (Move down) – when the menu appears on a panel
in the middle of the screen. To exit the condition use button (Exit) or press repeatedly button
(Cancel) until you reach the main menu.
The screens provided for parameter changes and command execution (command screens) are of
the lowest hierarchy. When a screen for parameter changes is activated, a pointer indicating the
current parameter, subject to changes, appears. The pointer may be visualized as:
 a cursor, indicating the position where:
 a symbol will be inserted – if there is a symbol under the cursor and a text at the
cursor’s right side, they will be moved one position to the right;
 a symbol will be deleted – if there is a symbol under the cursor, it will be deleted; the
text at the right side will be moved one position to the left; if there is no symbol under
the cursor, the symbol to the left will be deleted.
 an arrow, pointing over the parameter;
 a text in inversive colours.
To move between the parameters use buttons (next parameter) and (previous parameter).
When a parameter is changed, in the bottom left section of the panel appears the reminder Data not
saved. To save the changes press button and the reminder Data not saved is cleared.
Menu Set Up contains the following subordinate menus and functions:
 Panel configuration;
 Panel parameters;
 Loops;
 Zones;
 Inputs;
 Initialization;
 Checks;
 New Passwords;
 Default parameters;
 Clear Archive.
13.2. Menu Panel configuration
The menu is used to set up:
 the local network where the control panel is included in:
 if a local network is available, it can be switched on or off;
 if no local network is available, set the field to Off and the parameter will not be active;
 the periphery devices in the control panel:
 if periphery devices are present they can be switched on or off;
 if no periphery devices are present, the message None appears in the field and the
parameters remains inactive;
 the power loop – it can be switched On or Off;
 the language of the messages – language options are Bulgarian or English;
 Check for earth – it can be swithed On or Off the check for connection between the wires,
which exit from the panel wires and grounded metal partd or other wires.

UniPOS IFS7002 Specifications

General

Brand	UniPOS
Model	IFS7002
Category	Control Panel
Language	English