UniPOS IFS7002 User Manual

UniPOS IFS7002 two signal loops
Instruction Manual Page 103
Revision 11/01.17 Of 145
13.8. Menu Checks
The menu allows the user to set up the control panel outputs (monitored, relay and addressable),
the display and the buttons. It cointains the following submenus and functions:
 Menu Monitored outputs;
 Menu relay outputs;
 Menu Addressable outputs;
 Function Display;
 Menu Buttons.
13.8.1. Menu Monitored outputs
Using the menu you can run a check on control panel minitored outputs.
When you entere the meny
Monitored output 1 is triggered (if not
in Fault condition) and the following
screen appears:
At the activated monitored output
is displayed the message Yes, in
inversive colours; at the output not
activated yet is displayed the
message No in general colours.
When you press button or
the activated monitored output is
switched off and the other output is
activated (if not in fault condition).
Upon exit of the menu the activated monitored output is switched off.
13.8.2. Menu Relay outputs
Using the menu you can run a check on the relay outputs of the fire control panel.
When you enter the menu, Relay
output 1 is activated and the
following screen appears:
At the activated relay output
appears the message Yes in
inversive colours; at the realy output
not activated yet appears the
message No, in general colours.
When you press button or
the activated relay outputs is
switched off, and the other one is
activated.
Upon exit of the menu the activated relay output is switched off.
Mde:DAY LOC 14:02:46 Mon 28 Mar 2005
Check monitored Outputs
Activated Device:
Monitored Output 1 Yes
Monitored Output 2 No
Mode:DAY LOC 14:32:26 Mon 28 Mar 2005
Check relay Outputs
Activated Device
Relay Output 1 Yes
Relay Output 2 No

UniPOS IFS7002 Specifications

General

Brand	UniPOS
Model	IFS7002
Category	Control Panel
Language	English