14.26 Command: Pallet
• Compliant: The limit is the maximum speed the TCP is allowed to attain along/about the
axis. Units are [mm/s] and [deg/s].
• Non-compliant: The limit is the maximum deviation from the program trajectory which is
allowed before the robot protective stops. Units are [mm] and [deg].
Test force settings
The on/off button, labelled Test, toggles the behavior of the Freedrive button on the back of the
Teach Pendant from normal Freedrive mode to testing the force command.
When the Test button is on and the Freedrive button on the back of the Teach Pendant is
pressed, the robot will perform as if the program had reached this force command, and this
way the settings can be verified before actually running the complete program. Especially, this
possibility is useful for verifying that compliant axes and forces have been selected correctly.
Simply hold the robot TCP using one hand and press the Freedrive button with the other, and
notice in which directions the robot arm can/cannot be moved. Upon leaving this screen, the
Test button automatically switches off, which means the Freedrive button on the back of the
Teach Pendant is again used for regular Freedrive mode.
Note: The Freedrive button will only be effectual when a valid feature has been selected for the
Force command.
14.26 Command: Pallet
A pallet operation can perform a sequence of motions in a set of places given as a pattern (see
14.24). At each of the positions in the pattern, the sequence of motions will be run relative to
the pattern position.
e-Series II-96 Version 3.11
Copyright © 2009–2019 by Universal Robots A/S. All rights reserved.
To Next Page
Loading...
