14.33 Command: Variables Initialization
14.33 Command: Variables Initialization
This screen allows setting variable values before the program (and any threads) start executing.
Select a variable from the list of variables by clicking on it, or by using the variable selector box.
For a selected variable, an expression can be entered that will be used to set the variable value
at program start.
If the Keep value from previous run check-box is selected, the variable will be initialized to
the value found on the Variables tab (see 14.32). This permits variables to maintain their
values between program executions. The variable will get its value from the expression if the
program is run for the first time, or if the value tab has been cleared.
A variable can be deleted from the program by setting its name to blank (only spaces).
e-Series II-104 Version 3.11
Copyright © 2009–2019 by Universal Robots A/S. All rights reserved.
To Next Page
Loading...
