EasyManuals Logo

Uponor C-46 User Manual

Uponor C-46
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #39 background imageLoading...
Page #39 background image
CLIMATE CONTROLLER C-46 - INSTALLATION AND OPERATION MANUAL
39
Setting fixed dates for daylight saving time
To set fixed dates for daylight saving time, do this:
1. Set the required start and
end dates and press OK.
8.12.3 Language
The Language menu can be used to change the language used
on the display of the Climate Controller C-46:
1. Navigate through the screens using the navigation keys
Uponor > Main menu > General settings > Language
Example screen:
2. Select the required language.
Each language entry is presented in its own language as well
as in English. The following languades are selectable:
English (default language)
Svenska / Swedish
Dansk / Danish
Norsk / Norwegian
Suomi / Finnish
Deutsch / German
Nederlands / Dutch
Français / French
Italiano / Italian
Español / Spanish
Portoguês / Portoguese
8.12.4 Temperature unit
Temperatures displayed on the screen can be presented using
either the Celsius scale or the Fahrenheit scale.
To change the temperature scale:
1. Navigate through the screens using the navigation keys
Uponor > Main menu > General settings > Temperature
unit
Example screen:
2. Select the desired
temperature scale and
press OK.
8.12.5 Backlight
The backlight of the screen can be set in the following modes:
Always on
Dimmed when inactive
Off when inactive
To change the backlight mode, do this:
1. Navigate through the screens using the navigation keys
Uponor > Main menu > General settings > Backlight
Example screen:
2. Select the required
backlight mode and press
OK.
8.12.6 Log mode
To select the log mode, do this:
1. Navigate through the screens using the navigation keys:
Uponor > Main menu > General settings > Log mode
Example screen:
2. Select the required log mode, Detailed or Long term, and
press OK.
8.12.7 General purpose output
To select the general purpose output mode, do this:
1. Navigate through the screens using the navigation keys:
Uponor > Main menu > General settings >
General purpose output > Mode
Example screen:
2. Select the required general purpose output mode.
The following alternatives are available:
Inactive
H+C commands
Dehumidification
Fault signalling
Boiler demand
3. Confirm the selection by pressing OK.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Uponor C-46 and is the answer not in the manual?

Uponor C-46 Specifications

General IconGeneral
BrandUponor
ModelC-46
CategoryTemperature Controller
LanguageEnglish

Related product manuals