EasyManuals Logo

Uponor C-46 User Manual

Uponor C-46
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
CLIMATE CONTROLLER C-46 - INSTALLATION AND OPERATION MANUAL
27
2. Select
Act./deact. temp.
3. Set the parameter to the
required value and press
OK.
4. Select Delay.
5. Set the parameter to the
required value and press
OK.
6. Select Shut-off enable
period.
7. Set the parameter to the
required value and press
OK.
Note: Setting the start and end dates to be the same means
that the shut-off function is disabled.
Default dates: Start = 01 Aug, End = 01 Aug
Date ranges: Start = any date, End = any date
8.6 Cooling
This section describes how to set parameters when the Climate
Controller C-46 is working in Cooling or Heating and cooling
mode.
To bring up the Cooling menu:
1. Navigate through the screens using the navigation keys
Uponor > Main menu > Control settings > Cooling
Example screen:
Note that the items on the
Cooling menu are
dependent on the
selected operating mode.
2. The following list gives all possible sub-menus that can be
accessed from the Cooling menu. In several cases the
parameter setting is the same as when using the Quick menu
but with a slightly different layout.
Supply setpoint, section 8.6.1, page 27
Indoor setpoint, section 8.6.2, page 27
Min./max. supply, section 8.6.3, page 28
Indoor sensor influence, section 8.6.4, page 28
Dew point, section 8.6.5, page 28
Cooling activation, section 8.6.6, page 29
Dehumidifier control, section 8.6.7, page 29
3. Press OK to confirm the selection.
4. Continue the procedure as described in the referenced
section given in the list in step 2. above.
8.6.1 Supply setpoint
The supply setpoint is the temperature of the supply circuit that
the system regulates to reach.
To set the supply setpoint:
1. Navigate through the screens using the navigation keys:
Uponor > Main menu > Control settings > Cooling >
Supply setpoint
Example screen:
2. Select the desired set-point.
Default setting: 18 °C
Setting range: 5–40 °C
Setting accuracy: 0.5 °C
3. Confirm the setting by pressing OK.
8.6.2 Indoor setpoint
The indoor setpoint is the indoor temperature that the system
regulates to reach. This screen is applicable if a wired indoor
sensor is used.
To set the indoor setpoint:
1. Navigate through the screens using the navigation keys:
Uponor > Main menu > Control settings >
Heating > Indoor setpoint
Example screen:
2. Select the desired set-point.
Default setting: 20 °C
Setting range: 5–35 °C
Setting accuracy: 0.5 °C
3. Confirm the setting by pressing OK.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Uponor C-46 and is the answer not in the manual?

Uponor C-46 Specifications

General IconGeneral
BrandUponor
ModelC-46
CategoryTemperature Controller
LanguageEnglish

Related product manuals