CLIMATE CONTROLLER C-46 - INSTALLATION AND OPERATION MANUAL
40
8.12.8 GPO status
To display the General purpose output status:
1. Navigate through the screens using the navigation keys:
Uponor > Main menu > General settings >
General purpose output
Example screen:
The General purpose
output is set to off.
8.12.9 Controller ID
When one Controllers C-56 Radio are connected to the Climate
Controller C-46, it is possible to set their adresses in Climate
Controller C-46.
To display the Controller ID menu:
1. Navigate through the screens using the navigation keys:
Uponor > Main menu > General settings > Controller ID
Example screen:
2. Select the required item and press OK.
Set controller ID
To set a controller ID:
1. Navigate through the screens using the navigation keys:
Uponor > Main menu > General settings > Controller ID
> Set controller ID
Example screen:
The pointers > and < are
flashing on the first row.
2. Push the test button on the first Controller C-56 Radio.
When the Controller C-56 Radio is identified pointers stop
flashing and a new pair of pointer start flashing on the next
row.
3. Repeat step 2. for the remaining Controllers C-56 Radio.
4. When all Controllers C-56 Radio are identified, press OK to
confirm.
Reset controller ID
To reset all controller IDs:
1. Navigate through the screens using the navigation keys:
Uponor > Main menu > General settings > Controller ID
> Reset controller ID
Example screen:
2. Select Yes or No and press OK to confirm.
8.12.10 Software version
To display the software version of Climate Controller C-46, do
this:
1. Navigate through the screens using the navigation keys:
Uponor > Main menu > General settings >
Software version
Example screen:
X.X.X = software version
(X.X.X) = hardware
version
8.13 Radio links
The radio links functions can be used when a radio antenna is
connected to the Climate Controller C-46 and one or more
thermostats or Relative Humidity Sensors H-56 are installed in
the house.
The following screens are accessible from the Radio links menu.
1. In the Radio links menu, select the required item and press
OK.
Example screen:
2. Select the required item and press OK.
• View links, section 8.13.1, page 41
• Add links, section 8.13.2, page 41
• Reset all links, section 8.13.3, page 41
• Test radio range, section 8.13.4, page 41