Urschel COMITROL 1700 - Page 81

4
contents
MAINTENANCE (continued)
LUBRICATION...............................37
Recommended Lubricant, Motor Lubrication...........37
COVERS AND GUARDS ........................38
Removal, Inspection, Installation ..................38
OIL MIST LUBRICATOR ASSEMBLY ................40
Operation .................................40
Lubricator Specifications, Inspection ................41
Disassembly ...............................42
Reassembly, Adjustments.......................43
FEED ASSEMBLY (2 & 3" Cutting Heads) ............44
Disassembly ...............................44
Inspection.................................45
Reassembly ...............................46
FEED ASSEMBLY (Microcut Head) .................47
Disassembly ...............................47
Inspection.................................48
Reassembly ...............................49
FEED ASSEMBLY (Slicing Head) ..................50
Disassembly ...............................50
Inspection.................................51
Reassembly, Adjustments.......................52
SPINDLE ASSEMBLY ..........................53
Spindle Repair..............................53
Inspection, Removal ..........................54
Installation ................................55
Disassembly ...............................56
Inspection.................................58
Reassembly ...............................61
CUTTING HEADS.............................64
Identifying Cutting Heads, Inspection ...............64
Resharpening Cutting Heads ....................65
MICROCUT HEAD ............................66
Identifying Microcut Heads, Disassembly .............66
Inspection.................................67
Reassembly ...............................68
MICROCUT BLADES ..........................70
ELECTRICAL ASSEMBLY .......................72
Inspection.................................72
Control Monitor Check .........................73
DRIVE PARTS ...............................74
Disassembly, Inspection........................74
Reassembly, Adjustments.......................75
TROUBLESHOOTING ..........................76