11
SAFETY
Safety Signs
Figure 4 — Danger label, removed guard
Figure 5 — Danger and hazard alert labels
11667
DANGER
PELIGRO
MUST BE OPENED AND SERVICED BY
QUALIFIED ELECTRICIAN ONLY. INSTALL
TO MEET APPLICABLE CODES.
DEBE SER ABIERTO Y REPARADO POR UN
ELECTRICISTA CALIFICADO SOLAMENTE.
INSTALAR DE ACUERDO A LOS CODIGOS
CORRESPONDIENTES.
220 VOLTS ~
12716
11665
MACHINE IS UNGUARDED.
REPLACE GUARD OR COVER.
LA MAQUINA ESTA SIN PROTECCION.
VOLVER A COLOCAR EL PROTECTOR
O CUBIERTA.
DANGER
PELIGRO
w
Danger labels (Figure 4) are visible
when a protective cover or guard has
been opened or removed.This label
warns you that the machine is unguarded
and must not be restarted until all covers
and guards are replaced.
w
A danger label and a hazard alert label
(Figure 5) are placed on the starter en-
closure to warn you that this is a source
of electrical hazard. The enclosure must
be opened and serviced by a qualified
electrician only and the installation must
meet applicable codes.The number on
the hazard alert label indicates the volt-
age requirements of the machine.
To Next Page
Loading...
