description of parameters vacon • 73
24-hour support +358 (0)40 837 1150 • Email: vacon@vacon.com
7
732 Response to thermistor fault
(2.6.17)
0 = No response
1 = Warning
2 = Fault, stop mode after fault according to ID506
3 = Fault, stop mode after fault always by coasting
Setting the parameter to 0 will deactivate the protection.
733 Response to fieldbus fault
(2.6.18)
Set here the response mode for the fieldbus fault if a fieldbus board is used. For more
information, see the respective Fieldbus Board Manual.
See parameter ID732.
734 Response to slot fault
(2.6.19)
Set here the response mode for a board slot fault due to missing or broken board.
See parameter ID732.
738 Automatic restart: Number of tries after underload fault trip
(2.8.10)
This parameter determines how many automatic restarts can be made during the trial
time set by parameter ID718.
0 = No automatic restart after Underload fault trip
>0 = Number of automatic restarts after Underload fault trip
739 Number of PT100 inputs in use
(2.7.24)
If you have a PT100 input board installed in your frequency converter you can choose
here the number of PT100 inputs in use. See also the Vacon I/O boards manual.
Note: If the selected value is greater than the actual number of used PT100 inputs, the
display will read 200ºC. If the input is short-circuited the displayed value is –30ºC.
740 Response to PT100 fault
(2.7.25)
0 = No response
1 = Warning
2 = Fault, stop mode after fault according to ID506
3 = Fault, stop mode after fault always by coasting
741 PT100 warning limit
(2.7.26)
Set here the limit at which the PT100 warning will be activated.
742 PT100 fault limit
(2.7.27)
Set here the limit at which the PT100 fault (F56) will be activated.
To Next Page
Loading...
Need help?
General
