Ceilometer CT25K
User’s Guide CT25K-U059en-2.1
12
If the tilt feature will be used (see section 2.4), observe this in the layout of
the foundation screws and pedestal placement.
2.3 Assembling the Unit
The CT25K Ceilometer is assembled in four stages:
1. Mount the pedestal on the foundation.
2. Attach the measurement unit to the pedestal.
3. Mount the shield on the measurement unit.
4. Connect the external cables.
1. Place the Pedestal on the foundation (or equivalent installation place) so
that the vertical leg of the pedestal faces East in the Northern hemisphere,
and West in the Southern hemisphere.
Figure 2-3 Mounting the Pedestal
If the tilt feature will be used (see section 2.4.), observe this in the layout of
the foundation screws and pedestal placement. Place the flat washers on the
foundation screws and fix the nuts (Figure 2-3).
2. Start mounting the measurement unit by rotating the friction ring of the
flange to the position shown in Figure 2-4 (the screw holes horizontally).
Remove the Allen head screws (2 pcs) and flat washers.
To Next Page
Loading...
