Ceilometer CT25K
User’s Guide CT25K-U059en-2.1
18
9. Exit from "Comms" and select "Save the Setting" from "File" menu
by name "CT25K".
Now there should be the text "CT25K" under the "Comms" application. From
now on PSION3 is ready to communicate with CT25K whenever "CT25K"
from the "Comms" application is chosen.
Connecting PSION3 to CT25K
Connect the cables as follows:
1. Connect the Terminal Cable CT3840 to the external connector J4 of
the Ceilometer.
2. Connect the RS cable to the Maintenance Cable
3. Connect the RS cable to the PSION3 computer.
Operation
Turn on both equipments, the CT25K and the PSION3 computer.
4. PSION3 is turned on for normal operation by pressing the key "Esc"
or by pressing the special "Psion" key (∪) together with "ON".
5. PSION3 is turned off by pressing the "Psion" key (∪) and "OFF"
Choose the configuration CT25K from the System screen and press ENTER.
The terminal is now ready for dialogue communication with the ceilometer.
Start the program by pressing ENTER. The prompt "CT:"should appear on
the screen. If not, check the cables and port settings (see Setting up PSION3
above).
The port has to be opened by command "OPEN" for giving commands. The
prompt CEILO> should appear. See Chapter 4 Operation.
For more information about communication see PSION3 manual included in
the delivery.
To Next Page
Loading...
