USER'S GUIDE ____________________________________________________________________
154 __________________________________________________________________ M211187EN-C
21. Install the end plug with its O-Ring.
- Insert the end plug carefully so that the thread is not damaged.
- Use a wrench to tighten the end plug hand-tight.
22. Re-connect the receiver/transmitter control cable plug to the
Visibility Sensor Controller FSC102. Make sure that the connector
locking mechanism has arrested.
23. Check repair success.
- Repeat the failed test steps.
- Proceed with troubleshooting in case this repair step was not
successful.
24. Close central compartment cover carefully after a successful repair
operation.
- Pay attention to the placement of the cover gasket ring
- Fix the four cover screws firmly and hand tight. See Figure 44
on page 141.
To Next Page
Loading...
