Vaisala FS11 - Figure 14 Connecting Measurement Unit

Chapter 3 ________________________________________________________________ Installation
VAISALA ________________________________________________________________________ 37
9. Connect the measurement unit cable plug to the connector at the
bottom of FSM102 (see Figure 14 below).
0201-068
Figure 14 Connecting Measurement Unit
The following numbers refer to Figure 14 above:
1
=
Measurement unit end gasket
2
=
Transmitter
3
=
Surface temperature probe
4
=
Receiver
10. Insert the measurement unit into the pole mast and lock it in the
correct orientation as discussed in section Location and Orientation
on page 20 with two 8-mm bolts (see Figure 14 above). The
transmitter and receiver heads can be identified by first locating the
surface temperature probe, which is closer to the transmitter.
11. Erect the mast.